Wellborn Driveway & Pavers Nationwide

Wellborn Driveway & Pavers: The Redwood City Owner’s Guide

We stock and install Wellborn-compatible driveway and paver components for Redwood City homes, with paver driveway installation running $7,000-$18,000 and concrete driveway installation at $4,500-$12,000 depending on substrate condition and square footage. Most Wellborn paver orders can be sourced within 48 hours through our network of fifty-plus vetted material brands, and we carry common edge restraints, joint sand, and sealant on every driveway truck. Homeowners usually discover a problem when pavers shift after winter rains, when the polymeric sand washes out from between stones, or when they notice the driveway pitch has reversed and water pools against the garage slab instead of running to the street.

Call (650) 560-7228

Which Wellborn Models This Applies To

Wellborn Cabinet, Inc. does not manufacture driveway pavers or hardscape products - they’re a cabinet and millwork company out of Ashland, Alabama. What we’re addressing here is the common mix-up we see in Redwood City: homeowners who’ve had Wellborn cabinets installed during a kitchen or bathroom remodel and now need the driveway or patio redone by the same contractor who handled the interior work. If you’re holding a Wellborn product manual and looking for paver specs, you’ve got the wrong literature.

That said, we regularly work with homeowners in Redwood City who want their exterior hardscape to match the material quality of their Wellborn cabinetry. The pavers we specify - Belgard, Techo-Bloc, and select Calstone products - are chosen for the same reason Wellborn specifies 3/4-inch plywood box construction instead of particle board: they hold up. To identify what you’ve got, check for stamped codes on the paver edge (Belgard marks their Catalina line with a “B-CAT” stamp, Techo-Bloc uses a raised dot pattern on their Blu series). For existing driveways, measure the paver thickness - 60mm for vehicular traffic, 80mm for heavy loads - and note the joint width, which tells us whether the original installer used traditional sand or polymeric. We source OEM-equivalent materials through our vetted brand network, and we’ll put the exact product name and spec in writing before any work starts.

Signs Your Wellborn Driveway & Pavers Is Failing

• Pavers rocking underfoot or tire. The bedding sand has eroded or compacted unevenly, often because the original installer skipped the 1-inch screeded sand base and went thinner. In Redwood City, where the clay-heavy soil in neighborhoods like Farm Hills expands and contracts with winter moisture, a skimped base shows up fast.
• Weeds growing through joints. The joint sand - whether traditional or polymeric - has washed out, leaving voids. This happens when the sealant degrades or was never applied, which is common on south-facing driveways that take full afternoon sun and thermal cycling.
• Water pooling where it didn’t before. The driveway has lost its pitch, usually from subgrade settlement or tree root intrusion. Redwood City’s mature oak canopy is beautiful until a root lifts your Belgard border course by two inches and redirects runoff toward your foundation.
• Chalky white residue on paver faces. That’s efflorescence, mineral salts migrating through the concrete. It’s cosmetic but signals moisture moving through the paver body, which accelerates freeze-thaw damage if you’re in a microclimate that drops below 32°F regularly.
• Edge restraints pulling away from the perimeter. The plastic or aluminum edging has failed, often because it was spiked into native soil instead of a concrete haunch. Once the edge goes, the field pavers migrate outward and the pattern unravels from the outside in.

Before

After

Replacement Cost & What’s Included

For Redwood City, paver driveway installation runs $7,000-$18,000, concrete driveway installation $4,500-$12,000, and driveway replacement $5,000-$14,000. The spread depends on three things we measure on every site walk: square footage, whether we can reuse the existing base (saves $1,500-$3,000), and whether permits are required for curb cuts or drainage modifications.

Every quote we write breaks out materials, labor, base preparation, and disposal separately. Under Clause 1 of the Haven Standard, that written price is locked before anyone picks up a tool; no change proceeds without a signed change order. The 365-Day Done Right Promise covers the installation, and we include a documented photo record of the excavation, base compaction, and final layout - standard, not an upgrade. For paver-specific work, we warranty against settling in year one and will re-level any area that drops more than 1/4 inch.

DIY or Call Us?

There’s no high-tension danger here like a garage door spring, but driveway work punishes shortcuts in ways that aren’t obvious until six months later. An owner can safely check: whether the paver is loose (lift it and look for missing sand), whether the edge restraint is still spiked solid, and whether downspouts are dumping water onto the driveway surface. What goes wrong in DIY: inadequate base compaction (we run a plate compactor in 6-inch lifts, not one pass), wrong sand type (concrete sand, not masonry sand, for the bedding layer), and misreading the pitch so water still pools after all that work.

We’ve redone three Redwood City driveways in the past two years where the homeowner got the excavation right, laid the pavers straight, and then watched the whole thing settle into a bowl because the base wasn’t compacted to 98% Proctor density. Measure twice, document once, build it so it doesn’t come back. Call (650) 560-7228 and we’ll give you a written price for the fix - or a free second opinion on your DIY plan if you want to know where the risk sits.

FAQs